FORD Info needed

Bardenracing42 · Joined: 26 Jul 2006 Posts: 336 Location: Eaton Rapids, MI

I am rebuilding a ford 302 engine (out of a 1998 mercury mountaineer). This is not for racing purposes, just a stock rebuild. I am a GM guy, so I'm a little out of my territory here and would be grateful for any information anyone could provide. If you know of a good website, that would be really good. Basically what I'm looking for are the stock engine specs (torque specs, bolt tightening sequence, etc.)

Thanks,
Brian

lansingsportsrage.com · Joined: 26 Jul 2006 Posts: 1085

monzilla80 · Joined: 07 Sep 2006 Posts: 65 Location: Holt

www.therangerstation.com

I use it alot for Ranger, Explorers and Bronco II's. Good luck.

Dennis ONeil · Joined: 26 Jul 2006 Posts: 426 Location: Eaton Rapids

Hey Brian, If you need to look in a manual for specs drop by my shop at 817 Hall.
_________________
Thanks
Dennis ONeil
www.oneilsauto.com

"A MIND IS LIKE A PARACHUTE.............WORKS BETTER WHEN OPEN"

Bardenracing42 · Joined: 26 Jul 2006 Posts: 336 Location: Eaton Rapids, MI

Thanks, everyone. That was good (and fast) feedback.

Forgive me for being a little slow, Dennis. I finally put two and two together about you being the owner of Oneil's repair. You are less than a mile from my house. I will stop by sometime if I can't get the info off the web.

Thanks again,
Brian

p.s. Once I get this vehicle repaired it will be for sale. I got it for next to nothing, so I can sell it way below blue book value and still make enough to buy a quart of oil for the race car